SOP: Placing RefPoints

Owned by Konrad Job
Last updated: Aug 08, 2022
3 min read

The following illustrates a standard operating procedure (SOP) for placing RefPoints in order to generate an orthosis model in RapidShell3D.

Prerequisites

  • 3D scan aligned in RapidShell3D

Refer to the following guide for more information:

SOP: Aligning 3D Scan in RapidShell3D

Goals

Place RefPoints on 3D scan in RapidShell3D
Generate an orthosis model based on the placed RefPoints

Procedure

  1. Click RefPoints from the toolbar.

     

  2. Click Yes.

     

  3. Use the middle-click of your mouse to place a point at the apex of the medial longitudinal arch (MLA).

     

  4. Use the middle-click of your mouse to place a point at the widest point of the lateral heel.

     

  5. Use the middle-click of your mouse to place a point at the widest point of the medial heel.

     

  6. Use the middle-click of your mouse to place a point at the point in which you would like the orthosis shell to end in width and length at the lateral forefoot.

     

  7. Use the middle-click of your mouse to place a point at the point in which you would like the orthosis shell to end in width and length at the lateral forefoot.

     

  8. Click Accept

     

  9. A red orthosis model will now be generated based on the RefPoints placed on the foot. The generation of this red orthosis model will also be dependent on prescriptive variables input into your LaserCAM Prescribe prescription.

You are now ready to modify your red orthosis model based on the requested prescriptive variables.

Related SOP's

 

There are no related labels.

Â