The following illustrates a standard operating procedure (SOP) for adjusting the length of the red orthosis model in RapidShell3D.
Prerequisites
Red orthosis model generated in RapidShell3D
Refer to the following guide for more information:
Goals
- Adjust the length of the red orthosis model in RapidShell3D
Relevant Prescriptive Variables
Adjusting Orthosis Length
Clicking the up arrow will increase the medial length. Clicking the down arrow will decrease the length.
Click Yes.
Use the
middle-clickof your mouse to place a point at the apex of the medial longitudinal arch (MLA).
Use the
middle-clickof your mouse to place a point at the widest point of the lateral heel.
Use the
middle-clickof your mouse to place a point at the widest point of the medial heel.
Use the
middle-clickof your mouse to place a point at the point in which you would like the orthosis shell to end in width and length at the lateral forefoot.
Use the
middle-clickof your mouse to place a point at the point in which you would like the orthosis shell to end in width and length at the lateral forefoot.
Click Accept
A red orthosis model will now be generated based on the RefPoints placed on the foot. The generation of this red orthosis model will also be dependent on prescriptive variables input into your LaserCAM Prescribe prescription.
You are now ready to modify your red orthosis model based on the requested prescriptive variables.