...
Refer to the following guide for more information:
Relevant Prescriptive Variables
| Info |
|---|
Please reference the following prescriptive variables on the prescription form and ensure that the computer-aided design complies with your specific laboratory standard. |
Goals
- Adjust the length of the red orthosis model in RapidShell3D
...
Adjusting Orthosis Length
Clicking the up arrow will increase the medial length. Clicking the down arrow will decrease the medial length.
Click Yes.
Use the
middle-clickof your mouse to place a point at the apex of the medial longitudinal arch (MLA).
Use the
middle-clickof your mouse to place a point at the widest point of the lateral heel.
Use the
middle-clickof your mouse to place a point at the widest point of the medial heel.
Use the
middle-clickof your mouse to place a point at the point in which you would like the orthosis shell to end in width and length at the lateral forefoot.
Use the
middle-clickof your mouse to place a point at the point in which you would like the orthosis shell to end in width and length at the lateral forefoot.
Click Accept
A red orthosis model will now be generated based on the RefPoints placed on the foot. The generation of this red orthosis model will also be dependent on prescriptive variables input into your LaserCAM Prescribe prescription.
Clicking the up arrow will increase the lateral length. Clicking the down arrow will decrease the lateral
length.
Useful Tips
| Info |
|---|
The baseline grid is 10mm x 10mm. This can assist in ensuring that the length of the red orthosis model is the appropriate distance from the lowest point of the metatarsal head. |
...
| Tip |
|---|
You are now ready to modify your red orthosis model based on the requested prescriptive variables. |
...