This document will detail The following illustrates a standard operating procedure (SOP) for capturing and importing 3D scans using the LaserCAM VPS, or LaserCAM VPS Negative within LaserCAM Prescribe software.
Instructions
...
| Table of Contents |
|---|
...
Prerequisites
Active internet connection
LaserCAM Prescribe
...
Create a new prescription or continue an existing prescription
...
Related articles
| Filter by label (Content by label) | ||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
...
| hidden | true |
|---|
...
installed
LaserCAM VPS
Goals
- Connect LaserCAM VPS
- Capture 3D scan using LaserCAM VPS
Procedure
Connect 3D Scanner
Connect the provided power supply unit (PSU) to your LaserCAM VPS 3D scanner
Connect the USB cable into both the scanner and the USB port on your PC
Turn on the scanner by pressing in the red button on the side of the scanner
| Tip |
|---|
If the LaserCAM VPS is connected correctly, your PC should beep when you turn on the scanner. |
Configure LaserCAM VPS
Open LaserCAM Prescribe
Click New Prescription
You may pick any available prescription method
Click 3D Scans
Click the Devices dropdown from the top right hand corner of the screen
Select LaserCAM VPS
| Info |
|---|
If the LaserCAM VPS is not an available device, then you will need to re-install LaserCAM Prescribe. Please refer to our Getting Startedguide for more information. |
Capture Sample 3D Scan
Position the patient’s foot relative to the scanner.
Click Scan Left Foot → desired time delay
Place your hand in front of the 3D scanner surface and wait for scanning to initiate
Allow the scanner to complete two passes (up and back)
A 3D scan will now appear within your left foot window in LaserCAM Prescribe
| Info |
|---|
For information on how to assemble the LaserCAM VPS |